How to adjust press brake die

How to adjust press brake die

Installation Adjustment

When installing the press brake die, it is necessary to check the state of the press brake and then install and debug the press brake according to the steps. Pay attention to personal safety when debugging the press brake.

Adjustment of Press brake

When installing the press brake die, we should first understand the performance of the press brake, open the press brake, adjust and check patiently, and see if the press brake can have dust used before, as well as iron debris. Prevent unnecessary trouble caused by late use

Press brake slide stroke adjustment

First check whether the thickness of the press brake die and the proportion of the upper and lower modules is normal. The general slider of the press brake needs to be controlled at the switch point of the travel line. This must be paid attention to, otherwise it will lead to the normal use of the mold, but some people still often make such mistakes.

Press brake travel module adjustment

After adjusting the press brake slide stroke, the next is the upper limit of the press brake module is adjusted, generally speaking, the press brake module to the highest point, is to set up the press brake module and switch. This can flow out of the position of the bending die block, through some of the above operations, then you can greatly increase the production efficiency.  In this process, it is also necessary to slow down the slider of the press brake. Because the press brake slider in the bottom dead point, must decelerate the press brake slider, so as to protect the press brake and the mold.

Adjust the gap of the press brake

Finally, the gap between the press brake die is adjusted. First measure the clearance between the press brake up module and the press brake low module. The reasonable clearance needs to be determined according to the plate folded.

Press brake Angle adjustment

Adjusting the bending Angle is also the most important link, press brake Angle selection is certainly related to product requirements, generally speaking, folding 90° mold, then the Angle must be set in the middle Angle must be greater than the Angle on both sides, sometimes may be tight, can be processed by adjusting the screw on the press brake.  After adjustment, do not modify the product without changing the requirements.  Then when bending, through the pressure gauge, calculate the accurate pressure number, pressure adjustment.  In order to avoid press brake die edge breakage.