Publish Time: 2021-11-11 Origin: Site
1. Cooling system maintenance
The water inside the water cooler needs to be replaced regularly, usually with a frequency of one month.
The water cooler is responsible for cooling the laser and other parts of the equipment as circulating water.
Long-term use of water quality reduction is easy to form scale, thus blocking the waterway, resulting in water flow decline,
reducing the cooling effect, so the regular replacement of water as the primary problem.
Water as far as possible to choose distilled water, if there is no condition can choose deionized water.
Each manufacturer has requirements for water quality, remember to meet the requirements,
otherwise long time use of substandard water quality will cause scaling inside the laser.
2. Dust removal system maintenance
The use of the fan for a long time will make the fan accumulate a lot of solid dust,
so that the fan produces a lot of noise, but also not conducive to exhaust and deodorization.
When the fan suction is insufficient and smoke exhaust is not smooth, first turn off the power,
remove the inlet pipe and outlet pipe on the fan, remove the dust inside,
and then stand the fan upside down, and pull out the fan blade inside, until clean, and then install the fan.
3. Optical path system maintenance
The sole purpose of the lens cleaning process is to remove contaminants from the lens and not cause further contamination and damage to the lens.
In order to achieve this goal, one should often use relatively less risky methods.
First, it is necessary to use air ball to blow off the floss on the surface of the component,
especially the lens with small particles and floss on the surface.
But do not use compressed air from the production line,
because these air will contain oil and water droplets, which will deepen the pollution of the lens
The second step is to apply acetone to clean the lens slightly.
Acetone at this level is almost anhydrous, which reduces the likelihood of lens contamination.
Cotton balls dipped in acetone must be cleaned under light and moved in circles.Once a cotton swab is dirty,
change it.Cleaning should be done at one time to avoid the generation of wave bars.
If the lens has two coated surfaces, such as a lens, each surface needs to be cleaned in this way.
The first side needs to be protected by a clean sheet of lens paper.)
4. Transmission system maintenance
In laser cutting machine, the transmission system is equivalent to the human hand heel.
Transmission system directly affect the normal operation and the service life of equipment,
laser cutting machine in the process of cutting for a long time will produce smoke,
tiny dust will be through the dust cap into the equipment, to adhere to the guide rail rack above,
long-term accumulation can increase the wear of guide rail rack, rack and guide rail was originally a more precision parts,
after a long time will cause the slider and the damage of the gear.Therefore, the guide rack to do dust cleaning regularly,
clean up the dust attached to the guide rack will be on the rack above the butter, lubricating oil on the guide.